Wuko Bogie Bender 9050

The Wuko Bogie Bender 9050 is designed to handle sheet metal bending on inside/outside curves as well as straight pieces. The support plates are able to be unlocked to rotate freely around tight curves while still providing support edges for a crisp bend.

Key Features:

• The max bending depth: 50mm or 2″
• Min. bending height: 5 mm/0.2”
• Max. bending height: 50 mm or 2”
• Bending capacity: 0.80 mm/0.031” (for all common materials)

Experts will benefit from the Wuko Bogie Bender’s versatility

Straight Panels:

The tool’s two swivel joints with three roller stops can be fastened within seconds due to two integrated locking pins. Two simple steps and you are all set: Bend away!

Switch back to curvy mode:

Unfasten the two locking pins by pulling out the black knobs and rotate both swivel joints through 30 degrees before locking the knobs back in place again: This setting allows the roller stops to follow the curves of the edge smoothly.

The outstanding dimensional accuracy of the bend puts this bendy tool ahead of its competition, especially on workpieces combining inner and outer radius.

Rounding off the package, the Wuko Bogie Bender features an angled bending wheel: Comes in handy for getting springy materials to true 90° or avoiding scratches on coated sheets.