Copper Soldering Bits
Cold-hammered copper soldering bits made of high-quality electrolytic copper – available in hammer form, cranked hammer form or point form – 250 g, 350 g and 500 g versions – flat fixing pin prevents the bit from turning – long-lived – hammer form and cranked hammer form with 3 bores spaced at the bottom side for improving heat absorption.
Pointed Tip – 250g, 350g, 500g
Hammer Tip – 250g, 350g, 500g
Hammer Cranked – 250g, 350g, 500g
Please contact Steetz Copper Craft for different sizes
For more information on these Copper Soldering Bits and other great Perkeo Tools visit their website:
New design and faster warm-up!
The same high product quality, a new design and a faster
warm-up due to an increase in surface area on the underside of
the soldering iron are the result of close cooperation with a
plumbing company that we know well.
The core drill holes and the chamfered edges on the underside of
the copper bit increase the surface area to be warmed up. This
facilitates a better distribution of the heart of the torch flame
and enables a faster warm-up.
Rigid positioning of the soldering iron
The flattened rear face of the steel shaft prevents the soldering
iron from turning away.
High thermal conductivity and retention due
to cold-rolled electrolytic copper as base material.
Due to the ideal thermal transfer of the electrolytic copper, the
soldering iron heats up to operational temperature in less than
45 seconds – in addition the base material guarantees maximum
thermal retention and thereby achieves a lower gas consumption